Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 70 (POWER WINDOWS)DESCRIPTION
2008 Mazda Tribute s Sport, 4WD
Section 70 (Power Windows): Description
2008 Mazda Tribute s Sport, 4WDSECTION Description
WARNING: This page is about a different car, the 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
The windshield consists of:
- Standard plastic and glass laminate safety glass.
- A window opening flange bonded with urethane adhesive.
The liftgate window consists of:
- A standard plastic and glass laminate safety glass.
- A heated window grid wire.
- Two liftgate window glass hinges.
- Two liftgate lifting cylinder anchors.
- A window wiper motor and arm.
- A striker.
The front door window consists of:
- A standard plastic and glass laminate safety glass.
- A manual window regulator crank handle (if equipped).
- A window control switch (if equipped).
- A window regulator assembly, which consists of:
- A manual window regulator.
- A power window regulator and motor.
The rear door window glass consists of:
- A standard plastic and glass laminate safety glass.
- A manual window regulator crank handle (if equipped).
- A window control switch (if equipped).
- A window regulator assembly, which consist of:
- A manual window regulator.
- A power window regulator and motor.
The rear quarter window consists of:
- A standard plastic and glass laminate safety glass.
- A window opening flange bonded with urethane adhesive.
- Foam butyl sealant.
The window control switch:
- Is located on each door trim panel.
- May be used to raise or lower both passenger-side and driver-side windows from the window control switch on the driver door.
- Includes a window lock feature that is controlled through the window control switch on the driver door.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.