Power antenna inspection

2008 Mazda Tribute s Sport, 4WDSECTION Power antenna inspection
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. With audio on and at radio mode, first press the POWER button and hold it, then press the SAT button for approximately 1 second.Β 
  2. Inspect the power antenna according to the following table:
    POWER ANTENNA INSPECTION

    Inspection Display Action
    Start power antenna inspection mode. NORMAL
    Ant - OnΒ 
    POWER ANTENNA OPERATING SIGNAL IS OUTPUT
    Speakers output sound. System is okay.
    Speakers do not output sound. Inspect power antenna and wiring harness between base unit and power antenna.
    MALFUNCTIONING
    AMP - OFΒ 
    AUDIO AMPLIFIER OPERATING SIGNAL IS NOT OUTPUT
    Replace base unit.
  3. Turn the audio off or the ignition switch to the LOCK position to stop the diagnostic assist function.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.