Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 513 (ENGINE CONTROL SYSTEM)INTAKE AIR TEMPERATURE (IAT) SENSOR INSPECTIONINSPECTION OF RESISTANCE
2008 Mazda Tribute s Sport, 4WD
Inspection of Resistance
2008 Mazda Tribute s Sport, 4WDSECTION Inspection of Resistance
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Perform the following test only when directed.
- Disconnect the IAT sensor connector.
- Remove the IAT sensor.
- Place the IAT sensor in water with a thermometer, and heat the water gradually.
- Measure the resistance of the IAT sensor using an ohmmeter.
- If IAT sensor is okay, but PID value is out of specification, perform the CIRCUIT OPEN/SHORT INSPECTION .
- If not as specified, replace the IAT sensor.
Specification
Water temperature (°C {°F}) Resistance (kilohm) 20 {68} 2.21-2.69 80 (176} 0.29-0.354 - Reconnect the IAT sensor connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.