Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 513 (ENGINE CONTROL SYSTEM)CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION
2008 Mazda Tribute s Sport, 4WD
Crankshaft Position (CKP) Sensor Removal/Installation
2008 Mazda Tribute s Sport, 4WDSECTION Crankshaft Position (CKP) Sensor Removal/Installation
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the CKP sensor connector.
- Remove the undercover.
- Remove the CKP sensor installation bolt.
- Install in the reverse order of removal.
Tightening torque
- 7.9-10.7 N.m {80-110 kgf.cm, 69.5-95.4 in.lbf}
- Reconnect the CKP sensor connector.NOTE:
- Do not forcefully pull the wiring harness of the CKP sensor.
- Adjust the air gap. (See CRANKSHAFT POSITION (CKP) SENSOR ADJUSTMENT .)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.