Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 47 (ENGINE CONTROLS - SELF-DIAGNOSTICS)SYSTEM TESTSTACHOMETER OUTPUT FAILURE
2008 Mazda Tribute s Sport, 4WD
Tachometer Output Failure
2008 Mazda Tribute s Sport, 4WDSECTION Tachometer Output Failure
WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.
- Check CTO Circuit For Short To Power
Install breakout box, leaving PCM disconnected. With KOEO, measure voltage of CTO circuit between breakout box terminal No. 48 and ground. Turn ignition off. If voltage is less than 0.5 volt, go to next step. If voltage is 0.5 volt or more, repair short circuit. See WIRING DIAGRAMS article. Verify symptom no longer exists. - Check CTO Circuit For Short To Ground In Harness
Disconnect PCM connector. Disconnect instrument cluster 16-pin connector C214. Measure resistance between breakout box terminal No. 48 (CTO SIG circuit) and terminals No. 51, 76, 77 or 103 (PWR GND circuits) and chassis ground. Record readings. Measure resistance between breakout box terminal No. 48 (CTO SIG circuit) and chassis ground. Record reading. If both resistance readings are more than 10,000 ohms, go to next step. If either resistance reading is 10,000 ohms or less, repair short in wiring harness. See WIRING DIAGRAMS article. Verify symptom no longer exists. - Check CTO Circuit For Open Harness
Measure resistance of CTO circuit (Tan/Yellow wire) between breakout box terminal No. 48 and instrument cluster 16-pin connector terminal No. 15. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open circuit. See WIRING DIAGRAMS article. Verify symptom no longer exists. - Check CTO Signal From PCM
Connect PCM connector. With KOER, measure voltage of CTO circuit (Tan/Yellow wire) between instrument cluster 16-pin connector terminal No. 15 and ground. If voltage is 3-9 volts, see appropriate INSTRUMENT PANEL article in ACCESSORIES & EQUIPMENT. If voltage is not 3-9 volts, an open or short is present in PCM. Replace faulty PCM. Verify symptom no longer exists.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.