Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 450 (CHARGING SYSTEM)GENERATOR INSPECTIONGENERATOR INNER PARTSBRUSH SPRING
2008 Mazda Tribute s Sport, 4WD
Brush spring
2008 Mazda Tribute s Sport, 4WDSECTION Brush spring
WARNING: This page is about a different car, the 2005 Mazda RX-8 and 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Measure the force of the brush spring using a spring pressure gauge.
- Read the spring pressure gauge at the brush tip projection of 2 mm {0.079 in}.
- Replace the brush spring if necessary.
Standard spring force
- 4.8-6.0 N {0.49-0.61 kgf, 1.08-1.34 lbf}
Minimum spring force
- 2.16 N {0.22 kgf, 0.49 lbf}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.