Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 447 (FUEL SYSTEM)FUEL INJECTOR INSPECTIONRESISTANCE INSPECTION
2008 Mazda Tribute s Sport, 4WD
Resistance Inspection
2008 Mazda Tribute s Sport, 4WDSECTION Resistance Inspection
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch to the LOCK position.
- Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION .)
- Remove the extension manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
- Disconnect the fuel injector connector.
- Measure the resistance between terminals A and B of the fuel injector using a tester.
- If within the specification, perform out the "Circuit Open/Short Inspection".
- If not within the specification, replace the fuel injector.
Resistance
- Approx. 13.8 ohms [20 °C {68 °F}]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.