Quarter Window Glass Installation

2008 Mazda Tribute s Sport, 4WDSECTION Quarter Window Glass Installation
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Keep the area free of dirt and grease, and do not touch the surface or the primer may not properly bond to the surface of the molding, which may cause leaks to occur.
  1. Apply primer to the edge of the quarter window glass and the inside of the quarter window molding, and allow the primer to dry for approximately 30 minutesΒ  .
  2. Apply sealant to the inside of the quarter window molding.
    Fig 1: Applying Sealant To Inside Of Quarter Window Molding
    G03701133Courtesy of MAZDA MOTORS CORP.
  3. Fit the quarter window molding onto the glass.
  4. Install the screws, and install the lock.
  5. Install the screws and nuts, and install the quarter window glass.
  6. Install the D-pillar trim. (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
  7. Install the C-pillar trim. (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.