SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 432 (GLASS/WINDOWS/MIRRORS)BASE INSTALLATION
2008 Mazda Tribute s Sport, 4WD

Base Installation

2008 Mazda Tribute s Sport, 4WDSECTION Base Installation
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Cut away all of the original sealant using a razor.
  2. Clean and degrease the ceramic coating on the glass and the base.
    CAUTION:
    • Keep the area free of dirt and grease, and do not touch the surface or the primer may not properly bond to the surface of the glass.
  3. Apply primer to the bonding area of the glass and the base.
    NOTE:
    • Use only glass primer on the glass, and body primer on the base. Allow the primer to dry for approximately 30 minutes.
  4. Apply a height of 3.0 mm {0.12 in}  sealant to the base.
    Fig 1: Applying Sealant To Base
    G03701164Courtesy of MAZDA MOTORS CORP.
  5. Center the base in the ceramic coating and press it onto the glass.
    Fig 2: Centering Base In Ceramic Coating
    G03701165Courtesy of MAZDA MOTORS CORP.
  6. Use isopropyl alcohol to remove any excess repair sealant.

    Hardening time of sealant 

    TEMPERATURE AND HARDENING TIME CHART

    Temperature Surface hardening time Time required unit car can be put into service
    5 °C {41 °F} Approx. 1.5 h Approx. 12 h
    20 °C {68 °F} Approx. 1 h Approx. 4 h
    35 °C {95 °F} Approx. 10 min. Approx. 2 h
  7. Install the rear view mirror.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.