Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 393 (INTERIOR TRIM)DASHBOARD REMOVAL/INSTALLATION

2008 Mazda Tribute s Sport, 4WD

Dashboard Removal/Installation

2008 Mazda Tribute s Sport, 4WDSECTION Dashboard Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the glove compartment.
Remove the console.
Remove the meter hood.
Remove the instrument cluster.
Remove the column cover.
Remove the lower panel.
Remove the steering shaft.
Remove the A-pillar trims.
Remove the front scuff plates.
Remove the front side trims.
Remove the side panels.
For vehicles equipped with the wire-type climate control unit, disconnect the wires for the front A/C unit. (See CLIMATE CONTROL UNIT REMOVAL .) (See CLIMATE CONTROL UNIT INSTALLATION .)
Disconnect the dashboard harness connectors.
Remove the bolts.

Fig 1: Removing Dashboard Bolts (Torque Specs)
Courtesy of MAZDA MOTORS CORP.
Pull out the support pins from the body to remove the dashboard.
WARNING:
- Removing the dashboard without supporting it can be dangerous. The dashboard may fall and injure you. Always perform these procedures together with at least another person.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.