Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 363 (FRONT SUSPENSION SYSTEM)FRONT LOWER ARM (FRONT) REMOVAL/INSTALLATIONCLIP INSTALLATION NOTE

2008 Mazda Tribute s Sport, 4WD

Clip Installation Note

2008 Mazda Tribute s Sport, 4WDSECTION Clip Installation Note

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Wipe the grease off the ball stud.
Fill the inside of the new dust boot with grease.
Install the boot on the ball joint.
Install the new clip using the SST .

Fig 1: Installing Clip
Courtesy of MAZDA MOTORS CORP.
Verify that the clip is installed securely to the groove.
Wipe away the excess grease.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.