SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 355 (CHARGING SYSTEM)GENERATOR DISASSEMBLY/ASSEMBLYL3 (ATX)PULLEY DISASSEMBLY/ASSEMBLY NOTE
2008 Mazda Tribute s Sport, 4WD

Pulley disassembly/assembly note

2008 Mazda Tribute s Sport, 4WDSECTION Pulley disassembly/assembly note
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disassembly/assembly the pulley using the SST. 

    Tightening torque 

    60-85 N.m {6.1-8.7 kgf.m, 45-62 ft.lbf} 

    Fig 1: Removing Pulley Using SST
    G03644064Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.