Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Mode 6 (EVAP System Repair Verification Drive Mode)
2008 Mazda Tribute s Sport, 4WDSECTION Mode 6 (EVAP System Repair Verification Drive Mode)
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- If "EVAP System Repair Verification Drive Mode "cannot be performed (the vehicle under the specified condition), perform the EVAP system test procedure as an alternative. (See EVAPORATIVE EMISSION (EVAP) SYSTEM LEAK INSPECTION .)
- Verify that all of the following PIDs are within the following specifications. All PIDs must be within specifications before the engine is started to initiate the EVAP system test.
- BARO: 72.2 kPa {542 mmHg, 21.3 inHg} or higher
- IAT: 5-35 °C {41-95 °F}
- Fuel tank level: 15-85%
- Battery positive voltage: above 10.9 V
- Clear DTCs from the PCM memory using the WDS or equivalent.
- 3. Start the engine and idle it for 10 s or more , then turn ignition switch off.
- Leave the vehicle is this condition for 5 hours or more .
- Start the engine and idle it for 15 min or more .
- Drive the vehicle at the engine speed of 65-80 km/h {40-50 mph} for 5 min or more .
- Stop the vehicle and turn ignition switch off.
- Leave vehicle in this condition for 10 min or more.
- Start the engine.
- Access the ON BOARD SYSTEM READINESS menu of GENERIC OBD-II FUNCTION to verify the OBD monitoring status.
- If completed, the OBD monitoring status items change from non-completed to completed.
- If not completed, turn the ignition switch off, then repeat from Step 3.
- Access DIAGNOSTIC MONITORING TEST RESULTS menu of GENERIC OBD-II FUNCTIONS to verify the monitor results.
- If the detected values are not within the specification, the repair has not been completed.
- Verify that no DTCs are available.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.