Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 295 (GLASS/WINDOWS/MIRRORS)REAR DOOR GLASS REMOVAL/INSTALLATION
2008 Mazda Tribute s Sport, 4WD
Rear Door Glass Removal/Installation
2008 Mazda Tribute s Sport, 4WDSECTION Rear Door Glass Removal/Installation
WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Fully roll down the rear door glass.
- Remove the rear door trim.
- Remove the hole cover.
- Pull up the rear door weatherstrip and remove the screw.
- Remove the bolt.
- Remove the glass run channel from the rear door glass guide.
- Lift the rear door glass to the position where the rear door glass installation screw is visible.
- Remove the screw.
- Lift out the rear door glass.
- Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.