Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 254 (LIGHTING SYSTEM)TRUNK COMPARTMENT LIGHT SWITCH INSPECTION
2008 Mazda Tribute s Sport, 4WD
Trunk Compartment Light Switch Inspection
2008 Mazda Tribute s Sport, 4WDSECTION Trunk Compartment Light Switch Inspection
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The trunk compartment light switch is built into the trunk lock.
- Remove the trunk lid trim. (See TRUNK LID TRIM REMOVAL/INSTALLATION
- Disconnect the trunk compartment light switch connector.
- Verify that the continuity between the trunk compartment light switch terminals is as indicated. See Fig 1.
- If not as indicated, replace the trunk lock.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.