Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 242 (SYMPTOM TROUBLESHOOTING [ENGINE CONTROL SYSTEM 13B-MSP))ENGINE CONTROL SYSTEM OPERATION INSPECTIONFUEL PUMP SPEED CONTROL OPERATION INSPECTION
2008 Mazda Tribute s Sport, 4WD
Fuel Pump Speed Control Operation Inspection
2008 Mazda Tribute s Sport, 4WDSECTION Fuel Pump Speed Control Operation Inspection
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Perform the fuel pump operation inspection.
- Verify that fuel pump relay operation sound is heard, while cranking the engine.
- If operation sound is not heard, inspect the following:
- Fuel pump relay
- Wiring harnesses and connectors (Main relay-fuel pump relay-PCM terminal 4M)
- If operation sound is not heard, inspect the following:
- Remove the fuel-filler cap.
- Verify that the fuel pump unit operation sound frequency at cranking is higher than during idle.
- If it cannot verified, inspect for the following:
- Fuel pump resister
- Fuel pump relay
- Wiring harnesses and connectors (open circuit at fuel pump relay terminal C-fuel pump terminal B)
- If it cannot verified, inspect for the following:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.