Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 204 (AUTOMATIC TRANSAXLE (SERVICE))AUTOMATIC TRANSAXLE REMOVAL/INSTALLATIONSPRING INSTALLATION NOTE
2008 Mazda Tribute s Sport, 4WD
Spring Installation Note
2008 Mazda Tribute s Sport, 4WDSECTION Spring Installation Note
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- Install the selector lever to the manual shaft lever with spring side of the selector cable end facing the upward of the vehicle.
- Install the selector lever to the manual shaft lever in such a way that the selector cable does not bear a load.
- Confirm that the end of the manual shaft lever sticks out of the end of the selector cable.
NOTE:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.