Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1992 (STARTING SYSTEM)DIAGNOSIS AND TESTINGSTARTING SYSTEMSYMPTOM CHART

2008 Mazda Tribute s Sport, 4WD

Symptom Chart

2008 Mazda Tribute s Sport, 4WDSECTION Symptom Chart

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For hybrid starting system diagnostics, refer to the INTRODUCTION -- HYBRID .

SYMPTOM CHART

Condition	Possible Sources	Action
The engine does not crank	Battery Fuse(s) Starter motor Circuitry PCM Starter motor relay Anti-theft system Ignition switch Start diode Clutch cutoff switch Transmission Range (TR) sensor	GO to PINPOINT TEST A .
One-Touch Integrated Start (OTIS) does not operate correctly	Circuitry PCM	GO to PINPOINT TEST B .
The engine cranks slowly	Battery Starter motor Circuitry	CARRY OUT the Starter Motor Component Test.
Unusual starter noise	Starter motor mounting Starter motor Incorrect starter drive engagement	GO to PINPOINT TEST C .
The starter spins but the engine does not crank	Starter motor	INSPECT the starter motor mounting and engagement. REPAIR as necessary.
The starter spins but the engine does not crank	Damaged flywheel/ring gear teeth	INSPECT the flywheel/ring gear for damaged, missing or worn teeth. REPAIR as necessary.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.