Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test L: Radio Interference
Start engine. Tune radio to station where interference is present. Turn ignition switch to OFF position. Disconnect generator connector X-102a. See Figure. Start engine. Listen for interference with radio. If interference is still present, problem lies with audio system. Investigate and repair as necessary. If interference is not present, replace generator. See GENERATOR under REMOVAL & INSTALLATION. Retest system for normal operation.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.