Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1685 (FRONT DISC BRAKE SYSTEM)REMOVAL AND INSTALLATIONFRONT DISC BRAKE SYSTEM
2008 Mazda Tribute s Sport, 4WD
Front Disc Brake System
2008 Mazda Tribute s Sport, 4WDSECTION Front Disc Brake System
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 2B164 | Brake pad anti-rattle spring |
| 2 | - | Brake caliper dust boot caps (2 required) (part of kit 2L527) |
| 3 | - | Brake caliper guide pin bolts (2 required) (part of kit 2L527) |
| 4 | 2B121 LH/ 2B120 RH | Brake caliper |
| 5 | 2001 | Brake pad kit |
| 6 | - | Brake caliper dust boots (2 required) (part of kit 2L527) |
| 7 | W708519 | Brake caliper anchor plate bolts (2 required) |
| 8 | 2B540 | Brake caliper anchor plate |
| 9 | 1125 | Brake disc |
| 10 | - | Brake tube fitting |
| 11 | 2B223 | Brake flexible hose retaining clip |
| 12 | 2278 | Brake flexible hose |
| 13 | - | Bleeder screw cap (part of kit 2208) |
| 14 | - | Bleeder screw (part of kit 2208) |
- For additional information, refer to the procedures in this article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.