Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1628 (WIPER SYSTEM AND WASHER SYSTEM)DIAGNOSTIC TESTSWIPERS AND WASHERSINSPECTION AND VERIFICATIONNOTES
2008 Mazda Tribute s Sport, 4WD
Inspection and Verification: Notes
2008 Mazda Tribute s Sport, 4WDSECTION Notes
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern.
- Visually inspect for obvious signs of mechanical or electrical damage.VISUAL INSPECTION CHART
Mechanical Electrical - Windshield washer hoses
- Wiper linkage
- Multi-function switch
- Battery junction box (BJB) fuse 10 (30A)
- Smart junction box (SJB) fuses:
- 19 (25A)
- 43 (10A)
- 45 (5A)
- Circuitry
- Windshield wiper motor
- Rear wiper motor
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
NOTE:
The windshield wiper motor does not communicate on the network. The windshield wiper motor provides wiper on/off status directly to the smart junction box (SJB).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.