Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1561 (MODULE COMMUNICATIONS NETWORK SYSTEM)DIAGNOSTIC TESTSCOMMUNICATIONS NETWORKINSPECTION AND VERIFICATION
2008 Mazda Tribute s Sport, 4WD
Inspection and Verification
2008 Mazda Tribute s Sport, 4WDSECTION Inspection and Verification
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern.
- Visually inspect the following for obvious signs of electrical damage.VISUAL INSPECTION CHART
Electrical - Battery junction box (BJB) fuse(s):
- 4 (5A) (no communication with powertrain control module [PCM])
- 11 (10A) (no communication with PCM)
- 15 (30A) (no communication with anti-lock brake system [ABS] module)
- Smart junction box (SJB) fuse(s):
- 4 (10A) (no communication with the smart junction box [SJB])
- 6 (15A) (no communication with the SJB)
- 7 (10A) (no communication with instrument cluster, no power to scan tool)
- 17 (15A) (no communication with SJB)
- 18 (10A) (no communication with four wheel drive [4WD] control module)
- 22 (10A) (no communication with instrument cluster)
- 28 (10A) (no communication with instrument cluster)
- 29 (10A) (no communication with parking aid module)
- 33 (15A) (no communication with restraints control module [RCM])
- 34 (5A) (no communication with ABS module)
- 35 (5A) (no communication with 4WD control module)
- Data link connector (DLC)
- Wiring harness
- Circuitry
- Battery junction box (BJB) fuse(s):
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
NOTE:
Make sure to use the latest scan tool software release.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.