Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1550 (EXTERIOR LIGHTING SYSTEM)
2008 Mazda Tribute s Sport, 4WD
Section 1550 (Exterior Lighting System)
2008 Mazda Tribute s Sport, 4WDSECTION Section 1550 (Exterior Lighting System)
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnostic Tests
- Headlamps
- Notes
- Principles of Operation
- Inspection and Verification
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: Both Headlamps Are Inoperative
- Pinpoint Test B: The Low Beams Are Inoperative
- Pinpoint Test C: The High Beams Are Inoperative
- Pinpoint Test D: One Low Beam Headlamp Is Inoperative
- Pinpoint Test E: One High Beam Headlamp Is Inoperative
- Pinpoint Test F: The Headlamps Are On Continuously
- Pinpoint Test G: The Flash-To-Pass Feature Is Inoperative
- Autolamps
- Stoplamps
- Turn Signal and Hazard Lamps
- Notes
- Principles of Operation
- Inspection and Verification
- Symptom Chart
- Pinpoint Tests
- Parking, Rear and License Plate Lamps
- Fog Lamps
- Reversing Lamps
- Trailer Lamps
- Daytime Running Lamps (DRL)
- Headlamps
- General Procedures
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.