Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1358 (HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS)GENERAL PROCEDURESKEYLESS ENTRY KEYPAD CODE PROGRAMMING
2008 Mazda Tribute s Sport, 4WD
Keyless Entry Keypad Code Programming
2008 Mazda Tribute s Sport, 4WDSECTION Keyless Entry Keypad Code Programming
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Enter the permanent factory keyless entry keypad code.
- Press the 1/2 button within 5 seconds to activate the programming mode. Holding the 1/2 button for more than 2 seconds after activation erases the stored customer code. The door locks lock, then unlock, confirming the code is erased. The existing code does not need to be erased to program a new customer code.
- Within 5 seconds, enter the new 5-digit keyless entry keypad code. The door locks lock and unlock to confirm the new customer code is programmed.
- To exit the programming mode, wait 5 seconds.
NOTE:
The permanent factory keyless entry keypad code cannot be erased.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.