SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1355 (INFORMATION CENTER)GENERAL PROCEDURESCOMPASS ZONE ADJUSTMENTWITHOUT MESSAGE CENTER
2008 Mazda Tribute s Sport, 4WD

Without Message Center

2008 Mazda Tribute s Sport, 4WDSECTION Without Message Center
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Compass Calibration Zone Map
G03965509Courtesy of FORD MOTOR CO.
    NOTE: The compass zone setting is preset from the factory to Zone 8.
  1. Determine which magnetic zone you are in for your geographic location.
  2. Locate the compass module at the base of the mirror.
    Fig 2: Locating Compass Module At Base Of Mirror
    GF0004497Courtesy of FORD MOTOR CO.
  3. Turn the ignition key to the ON position.
  4. Press and hold the reset button on the LH top of the compass module until the current setting (1-15) area appears in the instrument cluster integrated display.
    Fig 3: Identifying Reset Button
    GF0004498Courtesy of FORD MOTOR CO.
  5. Press the reset button repeatedly to cycle through the zone settings until the correct setting for your geographic location is displayed.
  6. Release pressure on the reset button to exit the zone setting mode. After approximately 5 seconds the display reports the direction and the zone is set.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.