Front Fog Light Adjustment

2008 Mazda Tribute s Sport, 4WDSECTION Front Fog Light Adjustment
WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the tire air pressure to the specification.
  2. Position the unloaded vehicle on a flat, level surface.
  3. Seat one person in the driver's seat.
  4. Position the vehicle 3 m {10 ft}Β  in front of a white screen.
  5. While adjusting one fog light, mask the other.
  6. Start the engine to charge the battery.
  7. Turn the front fog light on.
    Fig 1: Setting Distance For Fog Light Adjustment
    G01196601Courtesy of MAZDA MOTORS CORP.
  8. Adjust the brightness border line by turning the adjusting bolts as shown in the figure. See Fig 2 . Loosen the bolts first, then tighten them.
NOTE:
  • If the adjusting bolts are tightened first, then loosened, they will continue to loosen when the vehicle is in motion and may cause the front fog lights to become misaligned.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.