Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (ENGINE CONTROLS - BASIC TESTING - 2.3L)FUEL SYSTEMFUEL PRESSUREFUEL PUMP
2008 Mazda Tribute s Sport, 4WD
Fuel Pump
2008 Mazda Tribute s Sport, 4WDSECTION Fuel Pump
WARNING: This page is about a different car, the 1997 Mazda Millenia. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel pump is located inside fuel tank. Locate data link connector in left side of engine compartment. Connect a jumper wire between data link connector terminals F/P and GND. See Figure . Remove fuel filler cap. Turn ignition on. Listen for fuel pump operation at fuel filler. Install fuel filler cap.
- If fuel pump does not operate, using DVOM, measure voltage between fuel pump connector power terminal and chassis ground. See FUEL PUMP CONNECTOR IDENTIFICATION table. If battery voltage is present, go to next step. If battery voltage is not present, repair power circuit to fuel pump. See appropriate wiring diagram in WIRING DIAGRAMS - 2.3L article.
- Using DVOM, check for continuity between fuel pump connector ground terminal and chassis ground. If continuity exists, replace fuel pump. If continuity does not exist, repair ground circuit.
FUEL PUMP CONNECTOR IDENTIFICATION
| Application | Power Terminal | Ground Terminal |
|---|---|---|
| Millenia | Yellow | Black |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.