Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM - EXCEPT HYBRIDCYLINDER HEAD TEMPERATURE (CHT) SENSOR - 2.3L REMOVAL/INSTALLATION
2008 Mazda Tribute s Sport, 4WD
Cylinder Head Temperature (CHT) Sensor - 2.3L Removal/Installation
2008 Mazda Tribute s Sport, 4WDSECTION Cylinder Head Temperature (CHT) Sensor - 2.3L Removal/Installation
Fig 1: Cylinder Head Temperature (CHT) Sensor With Torque Specifications -- 2.3L Replacement Components
- Detach the cylinder head temperature (CHT) sensor cover and position aside.
- Disconnect the CHT sensor electrical connector.
- Remove and discard the CHT sensor.
- To install, tighten to 12 N.m {1.2 kgf.m, 9 ft.lbf}.
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.