Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Powertrain Control Module (Pcm) - 3.0L (4V) Removal/Installation: Installation
2008 Mazda Tribute s Sport, 4WDSECTION Installation
- Install the PCM and the 2 stud bolts.
- To install, tighten to 9 N.m {0.9 kgf.m, 80 in.lbf}.
- Connect the 3 PCM electrical connectors.
- Position the manifold absolute pressure (MAP) sensor and the wiring harness and install the 2 PCM stud bolt nuts.
- To install, tighten to 9 N.m {0.9 kgf.m, 80 in.lbf}.
- Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. See PROGRAMMABLE MODULE INSTALLATION .
- Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. See KEY PROGRAMMING USING TWO PROGRAMMED KEYS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.