Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE I SPORT, FWD, STANDARDREPAIR AND DIAGNOSISSUSPENSIONFRONT SUSPENSIONSERVICE TOOLS [SUSPENSION SYSTEM - EXCEPT HYBRID]SERVICE TOOLS
2008 Mazda Tribute i Sport, FWD, Standard
Service Tools
2008 Mazda Tribute i Sport, FWD, StandardSECTION Service Tools
SERVICE TOOLS DESCRIPTION
| Mazda Required Tools | |
|---|---|
| Digital Tire Gauge AK5551311 |
|
| Activation Tool, Tire Pressure Monitor 204-363-TPMS |
|
| Axle Bearing Remover 205-193 (T83T-1225-A) |
|
| Differential Bearing Cup Replacer 308-153 (T88C-7025-BH) |
|
| Installer, Half Shaft 204-161 (T97P-1175-A) |
|
| Pinion Bearing Cup Replacer 205-014 (T60K-4614-A) |
|
| Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool | |
SERVICE TOOLS DESCRIPTION
| Tools or Equivalent | |
|---|---|
| Bearing Cup Replacer 205-278 (T88T-1175-C) |
|
| ChassisEAR 107-R2102 |
|
| EngineEAR 107-R2100 |
|
| Front Hub Remover 205-D070 (D93P-1175-B) |
|
| Front Hub Replacer 205-D069 |
|
| Handle 205-153 (T80T-4000W) |
|
| Impact Slide Hammer 100-D006(D79P-100-A) |
|
| Pinion Bearing Cone Remover 205-D002 (D79L-4621-A) |
|
| Radial Runout Gauge 418-F123 |
|
| Receiver Adapter 204-142 (T88C-5493-E) |
|
| Step Plate 205-D014 |
|
| Step Plate 205-239 |
|
| Tie Rod End Remover 211-105 |
|
| Vibration Analyzer 100-F027 |
|
| Wheel Bearing Adapter 205-D015 (D80L-630-4) |
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.