Fuel Pump Speed Control Operation Inspection

2008 Mazda RX-8 Touring, 1.3 N, RC4AELSECTION Fuel Pump Speed Control Operation Inspection
  1. Perform the fuel pump operation inspection.
  2. Verify that fuel pump relay operation sound is heard, while cranking the engine.
    • If operation sound is not heard, inspect the following:
      • Fuel pump relay
      • Wiring harnesses and connectors (Main relay-fuel pump relay-PCM terminal 4M)
  3. Remove the fuel-filler cap.
  4. Verify that the fuel pump unit operation sound frequency at cranking is higher than during idle.
    • If it cannot verified, inspect for the following:
      • Fuel pump resister
      • Fuel pump relay
      • Wiring harnesses and connectors (open circuit at fuel pump relay terminal C-fuel pump terminal B)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.