SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008CX-7 TOURING, 2.3 3, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMFUEL PUMP RESISTOR REMOVAL/INSTALLATION[L3 WITH TC]
2008 Mazda CX-7 Touring, 2.3 3, AWD

Fuel Pump Resistor Removal/Installation[L3 With TC]

2008 Mazda CX-7 Touring, 2.3 3, AWDSECTION Fuel Pump Resistor Removal/Installation[L3 With TC]
  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION[L3 WITH TC] ).
  2. Remove the air cleaner. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH TC] ).
  3. Disconnect the fuel pump resistor connector.
  4. Remove in the fuel pump resistor.
    Fig 1: Identifying Fuel Pump Resistor
    G04859652Courtesy of MAZDA MOTORS CORP.
  5. Install in the order as shown in the figure.

    Tightening torque 

    4.2-6.2 N.m {43-63 kgf.cm, 38-54 in.lbf} 

  6. Connect the fuel pump resistor connector.
    Fig 2: Identifying Fuel Pump Resistor Installation Bolts
    G04859653Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.