Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008CX-7 TOURING, 2.3 3, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMFUEL INJECTOR REMOVAL/INSTALLATION[L3 WITH TC]HIGH PRESSURE LINE PIPE INSTALLATION NOTE
2008 Mazda CX-7 Touring, 2.3 3, AWD
High Pressure Line Pipe Installation Note
2008 Mazda CX-7 Touring, 2.3 3, AWDSECTION High Pressure Line Pipe Installation Note
- Temporarily tighten the bolts in the order shown in the figure.
- Tighten NO. 1 bolts shown in the figure.
Tightening torque
17-23 N.m {1.8-2.3 kgf.m, 13-16 ft.lbf}
- Tighten NO. 2 bolts shown in the figure.
- Fix the joint nut with a wrench on the high pressure fuel pump side as shown in the figure.
- Tighten the high pressure line pipe installation nut.
Tightening torque
23.5-35.5 N.m {2.40-3.61 kgf.m, 17.4-26.1 ft.lbf}
- Tighten NO. 3, NO. 4 bolts shown in the figure.
Tightening torque
17-23 N.m {1.8-2.3 kgf.m, 13-16 ft.lbf}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.