Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008CX-7 TOURING, 2.3 3, AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLDYNAMIC STABILITY CONTROL SYSTEMREAR ABS WHEEL-SPEED SENSOR INSPECTION[2WD]CLEARANCE INSPECTION
2008 Mazda CX-7 Touring, 2.3 3, AWD
Clearance Inspection
2008 Mazda CX-7 Touring, 2.3 3, AWDSECTION Clearance Inspection
- Remove the rear ABS wheel-speed sensor.
- Measure the distance between the rear ABS wheel-speed sensor installation surface and the ABS sensor rotor. This is dimension A.
- Calculate the clearance between the front ABS wheel-speed sensor and the ABS sensor rotor using the following formula:
Clearance (mm {in}) = A-15.0
- Verify that the clearance between the ABS sensor rotor and the rear ABS wheel-speed sensor is as indicated below.
- If there is any malfunction, replace it.
Clearance
- 0.3-1.1 mm {0.012-0.043 in}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.