Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008CX-7 TOURING, 2.3 3, AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLDYNAMIC STABILITY CONTROL SYSTEMCOMBINED SENSOR REMOVAL/INSTALLATION
2008 Mazda CX-7 Touring, 2.3 3, AWD
Combined Sensor Removal/Installation
2008 Mazda CX-7 Touring, 2.3 3, AWDSECTION Combined Sensor Removal/Installation
CAUTION:
- The internal parts of the combined sensor could be damaged if dropped. Be careful not to drop the combined sensor. Replace the combined sensor if it is subjected to an impact. Also, do not use an impact wrench or other similar air tools when removing/installing the sensor.
- Remove the console panel. (See CONSOLE PANEL REMOVAL/INSTALLATION ).
- Remove the console. (See CONSOLE REMOVAL/INSTALLATION ).
- Remove in the order indicated in the figure.
- Install in the reverse order of removal.
- After installation, perform the combined sensor initialization procedure. (See COMBINED SENSOR INITIALIZATION PROCEDURE .)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.