SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008CX-7 TOURING, 2.3 3, AWDREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIMTRUNK SIDE TRIM REMOVAL/INSTALLATION
2008 Mazda CX-7 Touring, 2.3 3, AWD

Trunk Side Trim Removal/Installation

2008 Mazda CX-7 Touring, 2.3 3, AWDSECTION Trunk Side Trim Removal/Installation
  1. Remove the following parts:
    1. Rear seat (See REAR SEAT REMOVAL/INSTALLATION ).
    2. Rear scuff plate inner. (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    3. Sub trunk box (See SUB TRUNK BOX REMOVAL/INSTALLATION .)
    4. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
  2. Remove the screw.
  3. Pull the remote handle lever outward and detach clip A.
    Fig 1: Identifying Trunk Side Trim And Remote Handle Lever
    G04861272Courtesy of MAZDA MOTORS CORP.
  4. Remove the screws and the fastener.
  5. Remove the bolt, then remove the cargo net hook.
  6. Pull the trunk side trim outward and detach clips A and B.
  7. Remove the trunk side trim.
  8. Install in the reverse order of removal.
    Fig 2: Identifying Bolt, Cargo Net Hook, Screws And Clip
    G04861273Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.