SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008CX-7 TOURING, 2.3 3, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSBASE INSTALLATION
2008 Mazda CX-7 Touring, 2.3 3, AWD

Base Installation

2008 Mazda CX-7 Touring, 2.3 3, AWDSECTION Base Installation
  1. Cut away all of the original sealant using a razor.
    WARNING:
    • Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
  2. Clean and degrease the ceramic coating on the glass and the base.
    CAUTION:
    • Keep the area free of dirt and grease, and do not touch the surface. Otherwise, the primer may not properly bond to the surface of the glass.
  3. Apply primer to the bonding area of the glass and the base.
  4. Use only glass primer on the glass, and body primer on the base. Allow the primer to dry for approx. 30 min.
  5. Apply 3.0 mm {0.12 in}  layer of sealant to the base.
    Fig 1: Identifying Primer Applying Area With Specifications
    G04861078Courtesy of MAZDA MOTORS CORP.
  6. Center the base in the ceramic coating and press it onto the glass.
  7. Use isopropyl alcohol to remove any excess repair sealant.
    HARDENING TIME OF SEALANT

    Temperature Surface hardening time Time required until car can be put into service
    5°C {41°F} Approx. 1.5 h Approx. 12 h
    20°C {68°F} Approx. 1 h Approx. 4 h
    35°C {95°F} Approx. 10 min Approx. 2 h
  8. Install the rearview mirror.
    Fig 2: Identifying Ceramic Coating And Base With Specifications
    G04861079Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.