SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008CX-7 TOURING, 2.3 3, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSSECURITY SYSTEM AND LOCKS SYSTEMKEYLESS CONTROL MODULE CONFIGURATION[ADVANCED KEYLESS SYSTEM]
2008 Mazda CX-7 Touring, 2.3 3, AWD

Keyless Control Module Configuration[Advanced Keyless System]

2008 Mazda CX-7 Touring, 2.3 3, AWDSECTION Keyless Control Module Configuration[Advanced Keyless System]
  1. Connect the M-MDS to the DLC-2 connector.
  2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Module Programming".
    • When using the PDS (pocket PC)
      1. Select "Programming".
      2. Select "Module Programming".
  3. Then, select items from the screen menu in the following order.
    1. Select "Programmable Module Installation".
    2. Select "RKE".
  4. Perform the configuration according to the directions on the screen.
    Fig 1: Identifying DLC-2 Connector
    G04861158Courtesy of MAZDA MOTORS CORP.
  5. Retrieve DTCs by the M-MDS, then verify that there are no DTC present. If a DTC is present, perform the applicable DTC inspection. See DTC INSPECTION/IMMOBILIZER SYSTEM (ADVANCED KEYLESS SYSTEM)]
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.