Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008CX-7 TOURING, 2.3 3, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSSECURITY SYSTEM AND LOCKS SYSTEMIMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING[KEYLESS ENTRY SYSTEM]NO. 1 ADDITIONAL KEY REGISTRATION PROCEDURE (USING TWO VALID KEYS)PROCEDURE
2008 Mazda CX-7 Touring, 2.3 3, AWD
NO. 1 Additional Key Registration Procedure (Using Two Valid Keys): Procedure
2008 Mazda CX-7 Touring, 2.3 3, AWDSECTION Procedure
- Have one key (key 3) ready for registration.
- Using key 1, turn the ignition switch to the ON position.
- Verify that the security light illuminates for approx. 3 s and then goes out.
- Using key 1, turn the ignition switch to the LOCK position within approx. 4 s after the security light goes out.
- Remove key 1
- Repeat Steps 2- 5 using key 2.
- Repeat Steps 2- 5 using key 3.
- If additional keys need to be registered, repeat Steps 1- 7 in the same manner as key 3.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.