Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONMANUAL TRANSMANUAL TRANSAXLE [SERVICE, REMOVAL & INSTALLATION A65M-R)VEHICLE SPEED SENSOR REMOVAL/INSTALLATION (WITHOUT ABS) [A65M-R]
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Vehicle Speed Sensor Removal/Installation (Without Abs) [A65M-R]
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Vehicle Speed Sensor Removal/Installation (Without Abs) [A65M-R]
- Disconnect the negative battery cable.
- Remove the battery and battery tray.
- Remove the under cover.
- Disconnect the vehicle speed sensor connector.
- Remove the vehicle speed sensor.
- Apply transaxle oil to a new O-ring and install it on a vehicle speed sensor.
- Install the vehicle speed sensor.
Tightening torque
7.8-11.0 N.m
{80-112 kgf.cm, 57.6-81.1 in.lbf}
- Connect the vehicle speed sensor connector.
- Install the under cover.
- Install the battery and battery tray.
- Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.