Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONMANUAL TRANSMANUAL TRANSAXLE [SERVICE, REMOVAL & INSTALLATION A65M-R)REVERSE SWITCH REMOVAL/INSTALLATION [A65M-R]
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Reverse Switch Removal/Installation [A65M-R]
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Reverse Switch Removal/Installation [A65M-R]
- Remove the reverse switch.
- Apply a light coat of silicone sealant to the screw of the reverse switch.
Sealant
Three Bond product: TB1215
- Install the reverse switch to the transaxle case.
Tightening torque
22.5-33.3 N.m
{2.3-3.4 kgf.m, 16.6-24.6 ft.lbf}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.