Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (SYMPTOM TROUBLESHOOTING [AUTOMATIC TRANSAXLE AW6A-EL))
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Section 8 (Symptom Troubleshooting [Automatic Transaxle Aw6A-El))
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Section 8 (Symptom Troubleshooting [Automatic Transaxle Aw6A-El))
WARNING: This page is about a different variant/trim than selected.
- Automatic Transaxle Control System Wiring Diagram [Aw6A-El]
- Foreword [Aw6A-El]
- Basic Inspection [Aw6A-El]
- Symptom Troubleshooting Item Table [Aw6A-El]
- Quick Diagnosis Chart [Aw6A-El]
- No. 1 Vehicle Does Not Move In D Range, Or In R Position [Aw6A-El]
- No. 2 Vehicle Moves In N Position [Aw6A-El]
- No. 3 Vehicle Moves In P Position, Or Parking Gear Does Not Disengage When P Is Disengaged [Aw6A-El]
- No. 4 Excessive Creep [Aw6A-El]
- No. 5 No Creep At All [Aw6A-El]
- No. 6 Low Maximum Speed And Poor Acceleration [Aw6A-El]
- No. 7 No Shifting [Aw6A-El]
- No. 8 Does Not Shift To 6GR [Aw6A-El]
- No. 9 Abnormal Shifting [Aw6A-El]
- No. 10 Frequent Shifting [Aw6A-El]
- No. 11 Shift Point Is High Or Low [Aw6A-El]
- No. 12 Torque Converter Clutch (TCC) Non-Operation [Aw6A-El]
- No. 13 No KICKDOWN [Aw6A-El]
- No. 14 Engine Flares Up Or Slips When Upshifting Or Downshifting [Aw6A-El]
- No. 15 Engine Flares Up Or Slips When Accelerating Vehicle [Aw6A-El]
- No. 16 Judder Upon Torque Converter Clutch (TCC) Operation [Aw6A-El]
- No. 17 Excessive Shift Shock From N To D Or N To R Position/Range [Aw6A-El]
- No. 18 Excessive Shift Shock Is Given When Upshifting And Downshifting [Aw6A-El]
- No. 19 Excessive Shift Shock On Torque Converter Clutch (TCC) [Aw6A-El]
- No. 20 Noise Occurs At Idle When Vehicle Is Stopped In All Positions/Ranges [Aw6A-El]
- No. 21 Noise Occurs At Idle When Vehicle Is Stopped In D Range, Or In R Position [Aw6A-El]
- No. 22 No Engine Braking In 1GR Position Of M Range [Aw6A-El]
- No. 23 Transaxle Overheats [Aw6A-El]
- No. 24 Engine Stalls When Shifted To D Range, Or In R Position [Aw6A-El]
- No. 25 Engine Stalls When Driving At Slow Speed Or Stopping [Aw6A-El]
- No. 26 Starter Does Not Work [Aw6A-El]
- No. 27 Gear Position Indicator Light Does Not Illuminate In M Range [Aw6A-El]
- No. 28 Gear Position Indicator Light Illuminates In D Range Or P, N, R Positions [Aw6A-El]
- No. 29 Does Not Upshift In M Range [Aw6A-El]
- No. 30 Does Not Downshift In M Range [Aw6A-El]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.