SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (AUTOMATIC TRANSAXLE [SHIFT MECHANISM])SELECTOR LEVER COMPONENT REMOVAL/INSTALLATIONNOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Selector Lever Component Removal/Installation: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable.
  2. Remove the following parts.
    1. Battery and battery tray
    2. Air cleaner component (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION [L3] ) (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION [AJ] )
    3. Center console
    4. Dashboard completely (See DASHBOARD REMOVAL/INSTALLATION. )
    5. SAS control module (See SAS CONTROL MODULE REMOVAL/INSTALLATION )
    6. Climate control unit (See CLIMATE CONTROL UNIT REMOVAL [L3, AJ] ) (See CLIMATE CONTROL UNIT INSTALLATION [L3, AJ] )
    7. Rear heat duct (See REAR HEAT DUCT REMOVAL/INSTALLATION [L3, AJ] )
  3. Remove in the order shown in the figure.
  4. Install in the reverse order of removal.
    Fig 1: Selector Lever Components & Torque Specification
    G04326465Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.