Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (ENGINE MECHANICAL (SERVICE INFORMATION 2.3L L3))TIMING CHAIN REMOVAL/INSTALLATION [L3]ENGINE FRONT COVER INSTALLATION NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Engine Front Cover Installation Note
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Engine Front Cover Installation Note
WARNING: This page is about a different variant/trim than selected.
- Apply silicone sealant to the engine front cover as shown in the figure.CAUTION:
- Install the engine front cover within 10 min of applying the silicone sealant.
- Silicone sealant is not needed in the area indicated by C as shown in the figure as it is a seal.
Thickness
A: 2.0-3.0 mm {0.079-0.118 in}
B: 1.5-2.5 mm {0.059-0.098 in}
- Install the engine front cover bolts in the order as shown in the figure.TORQUE SPECIFICATIONS
Bolt No. Torque 1-18 8.0-11.5 N.m {81.6-117.2 kgf.cm, 70.9-101.7 in.lbf} 19-22 40-55 N.m {4.1-5.6 kgf.m, 29.7-40.5 ft.lbf}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.