SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (AUTOMATIC TRANSAXLE [SERVICE, REMOVAL & INSTALLATION FS5A-EL))AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [FS5A-EL]TRANSAXLE INSTALLATION NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Transaxle Installation Note

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Transaxle Installation Note
WARNING: This page is about a different variant/trim than selected.
  1. Set the transaxle on a jack and lift it.
  2. Install the transaxle mounting bolts.

    Bolt length (measured from below the head) 

    A: 50 mm {1.967 in} 

    B: 65 mm {2.559 in} 

    Tightening torque 

    37.3-52 N.m {3.8-5.3 kgf.m, 28-38 ft.lbf} 

    Fig 1: Locating Transaxle Mounting Bolts
    G04326293Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.