SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 19 (ON-BOARD DIAGNOSTIC (ENGINE CONTROL SYSTEM L3) (4 OF 5))DTC P0564 [L3]NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P0564 [L3]: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different variant/trim than selected.
DTC P0564 [L3] DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0564 Cruise control switch circuit malfunction
DETECTION CONDITION 
  • The PCM monitors the cruise control switch signal. If the PCM detects that any one of following switches (Main, CANCEL, SET/COAST, RESUME/ACCEL) remains on for 2 min  , the PCM determines that the cruise control switch circuit has a malfunction.

Diagnostic support note 
  • This is a continuous monitor (Other).
  • MIL does not illuminate.
  • PENDING CODE is available if PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is not available.
  • DTC is stored in PCM memory.
POSSIBLE CAUSE 
  • Cruise control switch malfunction
  • Connector or terminal malfunction
  • Short to power supply in wiring harness from cruise control switch terminal B and PCM terminal 1AQ.
  • Short to GND in wiring harness from cruise control switch terminal B and PCM terminal 1AQ.
  • PCM malfunction
G04324039Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.