Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 16 (ON-BOARD DIAGNOSTIC (ENGINE CONTROL SYSTEM L3) (1 OF 5))
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Section 16 (On-Board Diagnostic (Engine Control System L3) (1 Of 5))
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Section 16 (On-Board Diagnostic (Engine Control System L3) (1 Of 5))
WARNING: This page is about a different variant/trim than selected.
- On-Board Diagnostic Wiring Diagram [L3]
- Monitoring System And Control System Device Relationship Chart [L3]
- Foreword [L3]
- OBD-II Pending Trouble Code [L3]
- OBD-II Freeze Frame Data [L3]
- OBD-II On-Board System Readiness Test [L3]
- OBD-II Diagnostic Monitoring Test Results [L3]
- OBD-II Read/Clear Diagnostic Test Results [L3]
- OBD-II Parameter Identification (PID) Access [L3]
- On-Board Diagnostic Test [L3]
- After Repair Procedure [L3]
- KOEO/KOER Self Test [L3]
- OBD-II Drive Mode [L3]
- Notes
- PCM Adaptive Memory Production Drive Mode
- California emission regulation applicable ATX model
- Except California emission regulation applicable ATX model
- EGR System Repair Verification Drive Mode
- HO2S heater, HO2S, and TWC Repair Verification Drive Mode
- EVAP System Repair Verification Drive Mode
- Single Drive Mode
- Diagnostic Monitoring Test Results [L3]
- DTC Table [L3]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.