SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 13 (MANUAL TRANSAXLE [SERVICE, REMOVAL & INSTALLATION G35M-R))VEHICLE SPEED SENSOR REMOVAL/INSTALLATION (WITHOUT ABS) [G35M-R]
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Vehicle Speed Sensor Removal/Installation (Without Abs) [G35M-R]

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Vehicle Speed Sensor Removal/Installation (Without Abs) [G35M-R]
WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable.
  2. Remove the battery and battery tray.
  3. Remove the under cover.
  4. Disconnect the vehicle speed sensor connector.
  5. Remove the vehicle speed sensor.
  6. Apply transaxle oil to a new O-ring and install it on a vehicle speed sensor.
  7. Install the vehicle speed sensor.

    Tightening torque 

    7.8-11.3 N.m 

    {80-115 kgf.cm, 69.5-99.8 in.lbf} 

  8. Connect the vehicle speed sensor connector.
  9. Install the under cover.
  10. Install the battery and battery tray.
  11. Connect the negative battery cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.