DTC Table [FS5A-El]

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION DTC Table [FS5A-El]
WARNING: This page is about a different variant/trim than selected.
DTC CHART

DTC No. Condition MIL AT warning light illuminates DC Monitor item Memory function
DTC P0706  Transaxle range (TR) switch circuit range/performance ON YES 2 CCM X
DTC P0707  Transaxle range (TR) switch circuit low input ON YES 1 CCM X
DTC P0708  Transaxle range (TR) switch circuit high input ON YES 2 CCM X
DTC P0711  Transaxle fluid temperature (TFT) sensor circuit range/performance (stuck) ON NO 2 CCM X
DTC P0712  Transaxle fluid temperature (TFT) sensor circuit malfunction (short to ground) ON YES 1 CCM X
DTC P0713  Transaxle fluid temperature (TFT) sensor circuit malfunction (open circuit) ON YES 1 CCM X
DTC P0715  Input/turbine speed sensor circuit malfunction ON YES 1 CCM X
DTC P0720  Vehicle speed sensor (VSS) circuit malfunction ON YES 1 CCM X
DTC P0731  Gear 1 incorrect (incorrect gear ratio detected) OFF YES 1 CCM X
DTC P0732  Gear 2 incorrect (incorrect gear ratio detected) OFF YES 1 CCM X
DTC P0733  Gear 3 incorrect (incorrect gear ratio detected) OFF YES 1 CCM X
DTC P0734  Gear 4 incorrect (incorrect gear ratio detected) OFF YES 1 CCM X
DTC P0735  Gear 5 incorrect (incorrect gear ratio detected) OFF YES 1 CCM X
DTC P0741  Torque converter clutch (TCC) (stuck off) OFF YES 1 CCM X
DTC P0742  Torque converter clutch (TCC) (stuck on) OFF YES 1 CCM X
DTC P0744  Slip control malfunction OFF YES 2 CCM X
DTC P0745  Pressure control solenoid A malfunction OFF YES 1 CCM X
DTC P0751  Shift solenoid A stuck off ON YES 2 CCM X
DTC P0752  Shift solenoid A stuck on ON YES 2 CCM X
DTC P0753  Shift solenoid A malfunction (electrical) ON YES 1 CCM X
DTC P0756  Shift solenoid B stuck off ON YES 2 CCM X
DTC P0757  Shift solenoid B stuck on ON YES 2 CCM X
DTC P0758  Shift solenoid B malfunction (electrical) ON YES 1 CCM X
DTC P0761  Shift solenoid C stuck off ON YES 2 CCM X
DTC P0762  Shift solenoid C stuck on ON YES 2 CCM X
DTC P0763  Shift solenoid C malfunction (electrical) ON YES 1 CCM X
DTC P0766  Shift solenoid D stuck off ON YES 2 CCM X
DTC P0767  Shift solenoid D stuck on ON YES 2 CCM X
DTC P0768  Shift solenoid D malfunction (electrical) ON YES 1 CCM X
DTC P0771  Shift solenoid E stuck off ON YES 2 CCM X
DTC P0772  Shift solenoid E stuck on ON YES 2 CCM X
DTC P0773  Shift solenoid E malfunction (electrical) ON YES 1 CCM X
DTC P0777  Pressure control solenoid B stuck on ON YES 2 CCM X
DTC P0778  Pressure control solenoid B malfunction (electrical) ON YES 1 CCM X
DTC P0791  Intermediate sensor circuit malfunction ON YES 1 CCM X
DTC P0841  Oil pressure switch circuit malfunction OFF NO 2 CCM X
DTC P0882  Battery back-up power supply circuit malfunction ON NO 1 CCM X
DTC P0884  Battery voltage low ON YES 1 CCM X
DTC P0894  Forward clutch torque transmission OFF YES 1 CCM X
DTC P1783  ATF high oil temperature malfunction OFF YES 1 CCM X
DTC P2707  Shift solenoid F stuck off ON YES 2 CCM X
DTC P2708  Shift solenoid F stuck on ON YES 2 CCM X
DTC P2709  Shift solenoid F malfunction (electrical) ON YES 1 CCM X
U0073 CAN system communication error (See DTC TABLE [MULTIPLEX COMMUNICATION SYSTEM (L3, AJ )]).
U0100 Communication error to PCM (See DTC TABLE [MULTIPLEX COMMUNICATION SYSTEM (L3, AJ )]).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.