SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (ON-BOARD DIAGNOSTIC [AUTOMATIC TRANSAXLE FS5A-EL])DTC P0894 [FS5A-EL]NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P0894 [FS5A-El]: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different variant/trim than selected.
DTC P0894 [FS5A-EL] DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0894 Forward clutch power transmission malfunction
DETECTION CONDITION 
  • With the engine running, all of the following conditions are met:
    • ATF temperature 20°C {68°F} or more 
    • Vehicle speed 0 km/h {0 mph}  (brake on)
    • Even when 3 s or more have passed since the selector lever was shifted from the N position to the D range, the turbine speed will not decrease to less than 187 RPM.

Diagnostic support note: 
  • This is a continuous monitor (CCM).
  • The MIL does not illuminate if the TCM detects above malfunction conditions during the first drive cycle.
  • A PENDING CODE is not available.
  • FREEZE FRAME DATA is not available.
  • The AT warning light illuminates.
  • DTCs are stored in the TCM memory.
POSSIBLE CAUSE 
  • Forward clutch not engaged or slipped
  • Short to power supply in wiring harness between shift solenoid A terminal B and TCM terminal 1A
  • Shift solenoid A stuck on
  • VSS malfunction
  • TCM malfunction
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.